PRP Harnesses are installed and I also do some last minute details on prep of the RZR for the first season trip including the new UTV/Offroad TYT TH-8600 Weatherproof Dual Band Radio. Fits perfect in the RZR with included mounts. Cheaper clutch cover removal tool from amazon links to all products below. TYT TH-8600 Radio - http://amzn.to/2D5xf0i Clutch Cover Tool - http://amzn.to/2yD3WR9 Kimpex Storage Box - http://amzn.to/2g9S2GV Lock and Ride Mounts for Kimpex Box - http://amzn.to/2ydjbP6 Dual Band Antenna - http://amzn.to/2y941ch UHF Cable NMO Mount - http://amzn.to/2y9cJqR Seat Belt Sensor Override - http://amzn.to/2xwqmyf

Quick video of PRP GT SE Seats I installed in my Polaris RZR S 1000.

Quick overview of getting toyhauler and RZR S 1000 ready for the riding season. Installing Alba Racing cam tensioner, rock sliders, kimpex trunk, and PRP GT SE seat prep. Products used in this video: Kimpex Trunk - Amazon http://amzn.to/2vJfkcf Seat Belt Wire Harness - Amazon http://amzn.to/2vrgy9H Nylon Push Pins - Amazon http://amzn.to/2vntoqI

Final testing the design in a Polaris RZR S 1000.

Design for Manufacture and Final Testing before swapping out V1 to V1.2 in the RZR 1000S.

R&D on the RZR Canbus to enable turning on rocklights at low speed and get a reverse light signal.

In this video I rework boards used for reverse polarity testing to be used as test devices on the RS-485 bus.

Cut footage from the RZR multiplexer footage thanking an awesome company for doing things right. Best customer experience ever and a key tool to prototyping.

Quick review of the Aoyue 932 Vacuum Pickup Station.

Testing inputs - optoisolation.

Building a prototype, by hand, of the mini multiplexer board. I go over stencil paste for the PCB, hand placement of parts, and reflowing. Testing the first two boards of this revision.

Part 4 of the RZR Multiplexing project. Getting down to prototyping and testing of the main components. I also go over tools used and steps I take when developing a new product. Tools for PCB design using KiCad and sdcc development on the STM8S. I’ll also be switching some 12V loads for testing.